Technical Support

The guillotine shear is commonly used to cut sheet metals with straight edges. Its cutting process should ensure a good linearity and parallelism of the cutting surface while avoiding warp so as to get the high-quality workpiece.

>> More

The work principle of a mechanical shear is nearly the same as that of a mechanical press. However, the mechanical shear produces excessive noise, has no overload capacity, and is very difficult to adjust the blade gap. This type of machine, over time, has been phased out.

>> More

The standard provides the safety requirements for the design, manufacturing, and use of the press brake. The standard is applicable to the press brake which serves within its intended life span.

>> More

Check if all the machine parts are in good condition and whether the fastening screws and nuts are shaken loose or not. The brake should function properly and reliably.

>> More

The roll bender is a machine tool commonly used to curve plates. Its service life has direct affects on the company's profit-earning potential. Thus it is very important to incorporate maintenance into daily operations with an aim to achieve maximum durability, good energy-saving performance, and high production efficiency of the roll bender.

>> More

The hydraulic press brake can be divided into three varieties according to the different synchronization methods: torsion shaft synchronization, mechanical-hydraulic synchronization, and electro-hydraulic synchronization. The machine also falls into two types according to the different modes of motion of the bottom blade: fixed bottom blade or moving bottom blade.

>> More

The shearing machine is among the best-selling products in the tile press industry, second only to the power-generation equipment. In recent years, the burden on the power supply industry has been alleviated. What's more, the production volume of power-generation equipment has been increasing at a high speed through all these years.

>> More

Check the oil tank level on a weekly basis. Check it, for example, after the hydraulic system gets repaired. Refuel the tank when the oil level is lower than the bottom of the oil sight glass.

>> More